Huawei AR3200 Series Configuration Manual page 56

Huawei AR3200 Series Enterprise Routers
Configuration Guide - Device Management
Figure 2-8 Networking diagram of outputting information to the console
Router
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
Procedure
Step 1 Enable the information center.
<Huawei> system-view
Info: Current terminal monitor is on.
[Huawei] info-center enable
Info: Current terminal debugging is on.
Step 2 Allow the debugging on the ARP module to be output to the Console with the severity level of
the information as debugging.
[Huawei] info-center source arp channel console debug level debugging
[Huawei] info-center console channel console
[Huawei] quit
Step 3 Enable the terminal monitor function to display the debugging information.
<Huawei> terminal monitor
<Huawei> terminal debugging
Step 4 Enable ARP module debugging.
<Huawei> debugging arp packet
Step 5 Verify the configuration.
# View the configuration of the channel.
<Huawei> display channel 0
channel number: 0, channel name: console
MODU_ID
ffff0000 default
c16e0000 ARP
----End
Issue 03 (2011-11-27)
Console
Enable the information center.
Set the logs to be output to the console and the information module.
Configure the channel through which the debugging information is output.
Enable the terminal monitor function and display the debugging information.
Information channel number
Module enabled to output the logs
Information severity level
NAME ENABLE LOG_LEVEL
Y
Y
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
PC
ENABLE TRAP_LEVEL
warning Y
warning Y
2 Information Center Configuration
ENABLE DEBUG_LEVEL
debugging Y
debugging Y
debugging
debugging
48