Huawei AR3200 Series Configuration Manual page 48

Huawei AR3200 Series Enterprise Routers
Configuration Guide - Device Management
Router sends the logs (with a severity level as warning) generated on the Point-to-Point Protocol
(PPP) module and the AAA module to the log host Server 1. Server 4 functions as a backup
router of Server 2.
Both the Router s and the log hosts need to be configured.
Figure 2-5 Networking diagram of outputting logs to the log host
10.2.1.2/24
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
6.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
l
l
Procedure
Step 1 Configure routing protocols to make the router and log server routable. (The detailed procedure
is not mentioned here.)
Step 2 Configure the channel for outputting logs.
# Enable the information center.
Issue 03 (2011-11-27)
10.1.1.2/24 10.1.1.1/24
Server1
Server 3
Server 4
Server 2
10.2.1.1/24
Enable the information center.
Name the tunnel.
Specify the module enabled to output logs.
Configure the channel for outputting logs.
Configure the source interface that sends logs.
Configure the log host.
IP address of the log host
Information channel number
Name of the channel through which logs are output
Module enabled to output logs
Information severity level
Language in which the log is output
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
GE1/0/0
172.16.0.1/24
Router
2 Information Center Configuration
40