Figure 5-14. Speeder Plug Bracket Assembly - Woodward 3161 Governor Installation And Operation Manual

3161 Governor

Figure 5-14. Speeder Plug Bracket Assembly

11. Install speed setting lever (36), speed setting shaft (28) and clamp screw
(1). Use insert tool 8995-067 to install new speed setting shaft bearing.
Shaft (28) must rotate freely.
12. Place speed setting lever stop (29) on speed setting shaft (28) but do not
tighten clamp screw (32).
13. Place cover to case gasket (11) on the case. Install cover (10) and eight
cover screws (1). Leave screws loose.
14. Place gasket (3) on cover and install cover cover (2) with seven screws (1).
15. Install breather cap (4) on cover (10).
16. Install fitting (9) in case (26), and fitting (7) in cover (10). Install oil gauge (8)
in fitting (9) and connector (5) in top of the oil gauge. Install tube (6) in
fittings (5 and 7).
17. Attach governor nameplate (30) to front of governor with four screws (1).
Leave screws loose as they will be tightened after governor calibration.
26
This document, and more, is available for download from Martin's Marine Engineering Page - www.dieselduck.net
Manual 03101
Woodward