3161 Governor
3.
Remove three screws (1) and lift out speeder plug bracket (37),
shutdown/limit rod (40), limit floating lever (41), and limit rod (42).
4.
Carefully push down on speeder plug (123) and turn it until the floating lever
(125) is clear of the terminal lever. Lift speeder plug (123) and speeder
spring (122) out of the ballhead (Figure 5-3).
Figure 5-3. Speeder Plug Removal
Do not disassemble the speeder plug assembly unless part
replacement is necessary. To remove pin (126), place the assembly
on press fixture 8995-065. Use 1/8 inch pin punch and an arbor press
to press the pin from plug (123).
5.
Remove two screws (1) from the terminal lever (15). Pull output shafts (25)
from the terminal lever (15) and case (26).
6.
Lift terminal lever (15) up and rotate it to rest on the governor case. Remove
cotter pin (14) and headed pin (22) to separate the terminal lever from servo
connecting link (102). Remove seat (18) and spring (19) (Figure 5-4).
Figure 5-4. Terminal Lever Removal
16
This document, and more, is available for download from Martin's Marine Engineering Page - www.dieselduck.net
Manual 03101
Woodward