Section 2 - Mounting And Wiring; Mounting The 6270 - ADEMCO 6270 Installation And Setup Manual

N N N N N N N N N N N N N N N N N N N N N N N N N N N N N N N N
In This Section
o

Mounting the 6270

o Wiring the 6270
N N N N N N N N N N N N N N N N N N N N N N N N N N N N N N N N
Mounting the 6270
The 6270 should be mounted using the following criteria:
The 6270 must be mounted indoors, and
N
should be mounted at eye level for easy viewing by the user.
N
To mount the 6270, see Figure 1 and complete the following steps:
1. Detach the case back by pushing up into the two tabs located at
the bottom of the 6270 with the blade of a screwdriver while
pulling the case back and case front apart.
2. Locate the case back over the mounting surface such that the
opening in the case back is aligned with the wire/cable access
opening (in the mounting surface) while passing the wires/cable
through the opening in the case back.
3. Secure the case back to the mounting surface using four screws
(supplied).
Prior to attaching the case front to the case back, be sure to wire the
6270 as described in the " Wiring the 6270 " paragraph in this section.
S E C T I O N
Mounting and Wiring
2
2–1