ADEMCO 6270 Installation And Setup Manual page 12

6270 Installation and Setup Guide
DATA OUT (YELLOW)
+12VDC (RED)
GROUND (BLACK)
DATA IN (GREEN)
3. Connect the AUX – terminal of the control panel to the (–)
terminal of the supplementary power supply (black wire).
4. Connect the (–) terminal of the supplementary power supply to
terminal block position 3 (GND terminal of the 6270 (black wire)).
5. Connect Data Out terminal of the control panel to terminal block
position 1 (Data In terminal of the 6270 (yellow wire)).
6. Connect the Data In terminal of the control panel to header
terminal block position 4 (Data Out terminal of the 6270 (green
wire)).
7. Attach the case front of the 6270 to the case back. Attach the top
of the case first, and then press the bottom section inward until it
snaps into place securely.
2–4
Figure 3. Wiring the
6270
6270-002-V0