Section 4 - Initial Setup; Programming The Control Panel - ADEMCO 6270 Installation And Setup Manual

N N N N N N N N N N N N N N N N N N N N N N N N N N N N N N N N
In This Section
o Programming the Conrol
Panel
o 6270 Initialization
How to Change the ECP
o
Address
N N N N N N N N N N N N N N N N N N N N N N N N N N N N N N N N

Programming the Control Panel

The 6270 will not be fully operational unless its address in the control
panel has been enabled for an alpha console, AUI type device, and
assigned to a partition (where applicable). Refer to "Compatibility" on
page 1–2 of this document for the quantity of 6270s that may be used
and the required control panel software revision level.
On residential control panels (VISTA-20PS or equivalent), two
6270s may be used (addresses 1 and 2). These addresses (in field
*189) are enabled by default. If the defaults have been changed,
enable these addresses (in field *189) using an alpha-keypad and the
Data Field Programming procedures located in the panel Installation
and Setup Guide.
On commercial control panels (VISTA-128BP, VISTA-128FBP,
or equivalent), addresses between 1 through 30 may be used for the
6270. These addresses in the control panel are normally not defaulted
for AUI type devices. To enable the addresses you will be using for
6270s, use an alpha-keypad and follow the procedures for "Device
Programming" in your control panel "Programming Guide."
S E C T I O N
Initial Setup
o How to Access the Central
Station Screen
o 6270 Setup
Setting Chime Mode On/Off
o
4
4–1