6270 Initialization; Power Up; How To Change The Ecp Address - ADEMCO 6270 Installation And Setup Manual

6270 Installation and Setup Guide

6270 Initialization

Power Up

When initially powered, the screen displays the boot sequence as it is
performed. After it is determined what services are available, the
screen displays the Set ECP Address screen.
SCREEN

How to Change the ECP Address

After enabling addresses in the control panel using an alpha-keypad,
power up each 6270 one at a time, and set its address to one of the
addresses you enabled in the control panel. If this is a first time
power-up of the unit, follow the initialization procedure in this
section. Otherwise, access the Central Station screen then follow the
procedure to change the address on the unit.
4–2
ACTION
If the system is incorporating only one
6270, leave the address set to 1 and
press the OK button. The boot-up
process will continue until completion.
If there are to be additional 6270 units in
the system, refer to the How to Change
the ECP Address paragraph.