ADEMCO 6270 Installation And Setup Manual page 11

Connect the wires to the 6270 terminal block as follows:
1. The 6270 has holding clips on the case back to hold the case front
while you are wiring the unit. Hang the case front on the holding
clips as shown in Figure 2.
2. Connect the + terminal of the supplementary power supply to
terminal block position 2 (+12VDC terminal of the 6270 (red
wire)).
SECTION 2: Mounting and Wiring
CASE
FRONT
Figure 2. Wiring
Preparation
WALL OR
MOUNTING
SURFACE
CASE
BACK
6270-009-V0
2–3