Fuse Replacement; Cleaning - AEMC 6527 User Manual

4.2
WARNING: Make sure that no terminals are connected and that the
switch is in the OFF position before opening the back of the instrument.
To replace the fuse, proceed as follows:
• Set the switch to OFF.
• Disconnect the measurement leads from the input terminals.
• Using a screwdriver, unscrew the three screws of the battery com-
• Remove the blown fuse using a screwdriver.
• Insert a new fuse (HRC FF 0.5A–600V–6.3x32), then screw the
4.3
WARNING: Make sure that no terminals are connected and the range
switch is in the OFF position.
• Clean the body of the instrument with a cloth lightly moistened
• Wipe clean with a damp cloth.
• Dry with a dry cloth or forced air.
• Do not use alcohol, solvents or hydrocarbons.
24
0.561.8187

Fuse Replacement

partment cover located on the back of the housing.
cover back onto the housing.

Cleaning

with soapy water.
www.
Megohmmeter Model 6527
.com
information@itm.