Maintenance; Battery Replacement - AEMC 6527 User Manual

WARNING:
• For maintenance use only specified replacement parts.
• To avoid electrical shock, do not attempt to perform any servicing
unless you are qualified to do so.
• To avoid electrical shock and/or damage to the instrument, do not get
water or other foreign agents into the case. Turn the instrument OFF
and disconnect the unit from all the circuits before opening the case.
4.1
WARNING: Make sure that no terminals are connected and that the
switch is in the OFF position before opening the back of the instrument.
The
When this symbol appears on the display unit, the instrument continues to
operate for a few minutes, and then turns itself off.
To replace the batteries, proceed as follows:
• Set the switch to OFF.
• Disconnect the measurement leads from the input terminals.
• Using a screwdriver, unscrew the three screws of the battery com-
• Place the new batteries in the compartment making sure that the
• Screw the cover back onto the housing.
Megohmmeter Model 6527
0.561.8187

MAINTENANCE

Battery Replacement

symbol indicates that the batteries are low and must be replaced.
partment cover located on the back of the housing.
polarities are correct.
www.
CHAPTER 4
.com
information@itm.
23