3.6.1
To set the compensation of the resistance of the measurement leads, pro-
ceed as follows:
•
Short-circuit the black and red leads connected to the meter.
•
Hold the ZERO/
lowest value. The
•
Release the ZERO/
stored.
NOTE: Valid in V
3.7
The Model 6527 generates a DC voltage between the V-Ω and COM
terminals. It then measures the current across these two terminals and
from it calculates the value of R=V/I.
•
Turn the range switch to kΩ. The test voltage is generated without
pressing the test button.
•
Connect the black test lead to the (COM) terminal and the red one to
the (V-Ω) terminal.
•
Connect the test probe tips to the sample under test.
22
0.561.8187
Lead Resistance Compensation
button down until the display unit indicates the
, V
, Ω and kΩ positions only
AC
DC
Resistance Measurements
www.
symbol will display.
button. The correction value is displayed and
Figure 3-12
.com
Megohmmeter Model 6527
information@itm.