Battery And Fuse Replacement; Cleaning - AEMC 1015 User Manual

5.1.2

Battery and Fuse Replacement

WARNING: Make sure that no terminals are connected and that the
switch is in the OFF position before opening the back of the instrument.
• Remove the yellow shockproof housing.
• Remove the two screws from the back of the instrument (Fig. 11).
• Remove the back cover.
• Replace the fuse or batteries.
NOTE: There is a spare fuse installed in the back cover.
• Reverse the above procedure to install the back cover and the shock
proof housing.
• To close the back stand flush with the back cover, apply light pressure
at Point A in Fig. 11.
5.1.3

Cleaning

• Clean the body of the instrument with a cloth lightly moistened with
soapy water.
• Wipe clean with a cloth moistened with clean water and dry.
• Do not use solvent.
Megohmmeter Model 1015
Cover screws
Point A
Figure 11
1.6 A fuse
+
+
+
+
1.5 V batteries LR6
17