Upgrading Software Via Usb Flash Drive - Leica mojo3D User Manual

Leica mojo3D, Virtual Wrench™ Remote Service
9.4
General informa-
tion
Caution
Upgrading soft-
ware with a USB
Flash Drive, step-
by-step

Upgrading Software via USB Flash Drive

A new version of software may be installed from a USB Flash Drive.
Refer to "Appendix B Formatting USB Flash Drives" for important informa-
tion about using USB drives with the mojo3D products.
Do not turn off the mojo3D, or remove the USB Flash Drive, while the software
upgrade is under way.
To upgrade the mojo3D software via USB Flash Drive, carry out the following steps:
1. The USB interface is on the lower left front of the
mojo3D display. Lift the rubber cover and insert a
compatible USB Flash Drive into the USB slot.
mojo3D_010
124