Table of Contents
Advertisement
Software configu-
ration, step-by-
step
Leica mojo3D, mojo3D Enhancements
It's assumed that the initial setup for both, the mojoRTK Console and the
mojo3D display, already have been done.
To configure software for the mojo3D to mojoRTK connection, carry out the following
steps on the mojo3D:
1. On the main navigation screen, tap the Settings button.
2. On the flyout menu, tap the Attached device button.
3. Tap the mojoRTK button
4. Select the necessary correction type from the list.
This will depend on the particular installation and the method chosen for
GPS corrections, for example Base Station via internal radio.
5. Additional configuration information will need to be selected for most Correction
Source options. After setting this information tap
to continue.
to continue.
195
Advertisement
Table of Contents
