Leica mojo3D User Manual page 169

Installation
Leica mojo3D, mojo3D Enhancements
To install single-section control, carry out the following steps:
1. Connect the port expansion cable to the
mojo3D.
2. Connect the two grey wires from the relay to
the equipment which is to be switched.
The relay has a normally open contact which is closed when the mojo3D
switches the output on. The mojo3D can be configured to set the relay to
normally closed operation by selecting Planter as the Implement Mode.
mojo3D_013
mojo3D_020
169