Leica mojo3D User Manual page 39

Section control
setup,
step-by-step
Leica mojo3D, Running the mojo3D for the First Time
1. The section control setup screen initially shows one section, as a single blue bar
near the top of the screen. To set the number of sections, tap the number of
sections field, enter the number of sections, and tap
2. The blue bar will be divided showing the number of sections set. To set the width
of the first section, tap the section width field, enter the width measurement
and tap .
3. Tap at the top right corner of the screen, the selected section in the bar will
be coloured blue. Set the width of the section the same way by tapping on the
section width field.
When all sections widths are correctly set, the Implement Width shown
should match the total width of the physical implement.
4. If automatic section control is being used, then additional information will have
to be entered.
• Overlap limit: the percentage amount of overlap that is to be allowed before
the section is turned off.
• Low Speed Shutoff: the minimum travel speed for a section before it is
turned off.
• Off latency: the number of seconds it takes from the section being turned off
until the actual application stops.
• On latency: the number of seconds it takes from the section being turned on
until the actual application starts.
.
39