Electronics Line iconnect User Manual page 50

Hide thumbs Also See for iconnect:
Table of Contents

Advertisement

Non-Controlled
Code
One-Key Arming
Panic Alarm
Part Arming
Perimeter Arming
PGM
Ready
Remote Firmware
Update
Restore
RSSI
Scheduling
Detectors
Service Call
SMS Command
Smartkey
SMS Confirmation
System Status LEDs
N
A user code that does not cause the system to notify the monitoring
service when used to arm or disarm. The system only reports if the
code is used to disarm after an alarm.
O
Arming the system without the need for a valid user code.
P
A user initiated event that alerts the monitoring service in the event
of an emergency.
An arming method that is designed to activate a certain section of
the premises.
An arming method that is designed to activate the detectors
protecting the doors and windows while enabling residents to move
freely on the premises.
Programmable output that is triggered according to specific system
status conditions, or by remote command sent via PSTN, GSM,
Ethernet, keyfob, keypad, or Remote Programmer.
R
The state in which all zones are closed and the system is ready to be
armed.
Control System's firmware update from a remote PC using WEB
communication.
The restoral of a trouble condition to its normal state. For example, if
AC power is reconnected, an AC Loss Restore event code is sent to
the central station.
Received Signal Strength Indication (abbr.) RF noise of the system's
receiver.
S
A Home Automation feature that switches HA units on and off
automatically according to pre-set times.
The devices installed around the home that alert the panel in the
event of an alarm.
A feature that enables the user to contact the monitoring service and
talk to an operator via the Control System.
An SMS message sent to the Control System that causes the system
to perform a specific function.
An RF ID device used to arm and disarm the system by placing it
against the Wireless Keypad.
An SMS message sent to the user confirming that the SMS command
has been performed.
Luminous indicators on the front panel that provide information on
the arm and power status of the system.
-50-

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the iconnect and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Table of Contents