Checking The Front Brake Disc - Yamaha FZ-16 Service Manual

INTRODUCTION
WARNING
The disc brake components seldom
require disassembly. Therefore, always
follow these precautions:
Never disassemble the brake components, to
unless absolutely necessary.
If you disconnect any connections in the
brake hydraulic, must disarm all
the brake system, drain, clean,
properly fill and bleed after
assembling
Never use solvents on the components
Brake internal
Use only clean brake fluid or
again for the cleaning of the components
the brake.
Brake fluid can damage the surface
painted and plastic parts. Therefore,
Always wipe up the liquid
spilled brake.
Keep the brake fluid in contact
with eyes as it can cause serious injury.
FIRST AID FOR BRAKE FLUID TO
ENTERING THE EYES: Flush with water for 15
minutes and seek immediate medical attention.
CHECKING THE BRAKE DISC
FRONT
1. Remove:
Front Wheel
Refer to "FRONT WHEEL"
on page 4-6.
2. Check:
Brake disc
Damaged / Replace scratched.
3. Measure:
Deformation of the brake disc
Out of specification Correct deformation
Brake disc or replace the brake disc.
Limit disk deformation
Brake 0.10 mm
FRONT BRAKE
a.
Place the vehicle on a suitable support,
so that the front wheel is lifted.
b.
Before measuring the deformation of the disc
front brake, turn the handlebars to the left
or right to ensure that the wheel
front is fixed.
c.
Remove the brake caliper.
d.
Hold the comparator at right angles
relative to the surface of the brake disc.
e.
Measuring the deformation of the disc 5 mm
below the rim of the brake disc.
4.
Measure:
Thickness of brake disc
Measure thickness of brake disc
different locations.
Replace out of specification.
Limit the thickness of the disc
brake 3.5 mm
5.
Adjust
Deformation of the brake disc
a. Disassemble the brake disk
b. Rotate the brake disc of a screw hole
c. Disc brake assembly
Screw the brake disc
30 Nm (3.0 m · kg, 22 ft · lb)
T.
R. LOCTITE ®
NOTE:
Tighten the brake disc in stages
and in a crisscross pattern.
4-19