Inspection Of The Push Rod; Main Shaft Assy, Spindle Traction; Assembly Of The Forks Changes And Change Drum - Yamaha FZ-16 Service Manual

3.
Check:
Gears of workpool such knowledge within
l
Blue discoloration / pitting / wear
Replace defective gear.
Lace gear transmission
l
Cracks / damage / rounded edges
Replace defective parts.
4.
Check:
Gear transmission sprockets.
l
(Each sprocket wheel meshes in their respective
Gear)
Reassembly incorrect axes of the
transmission
5.
Check:
Movement of transmission gears
Replace parts coarse movement
l
defective.

INSPECTION OF THE PUSH ROD

CLUTCH
1.
Check:
Long rod Clutch thrust
Cracks / damage / wear Replace the
long rod thrust of the clutch.
l
2.
Measure:
Deformation limit of the push rod
Out of specification Replace
the long rod clutch thrust
l
Limit flexing of the rod
Thrust
0.500 mm
MAIN SHAFT ASSY, SPINDLE
TRACTION
1.
Install:
Adjust dial "1"
l
New
Pin lock "2"
l
NOTE:
Be sure to install the lock pin so
l
its sharp edge "to" be back to the
lock washer and gear.
Make sure the ends of the lock pin
l
"B" are placed in the groove of the groove axis "c".
New
2.
Install:
Pinion second "1"
l
NOTE:
Press the second sprocket on the main axis
"2", as shown in the illustration.
Mounting depth "a"
106.85-107.05 mm
ASSEMBLY OF THE FORKS
CHANGES AND CHANGE DRUM
1.
Install:
Left-shift fork "1"
l
Shift fork-Center "2"
l
Right-shift fork "3"
l
Drum changes "4"
l
Springs
Guide bar changes the grip of "5"
l
Guide bar changes the grip of "6"
l
l
5-65
TRANSMISSION