Set Cable Free Play Throttle - Yamaha FZ-16 Service Manual

CAUTION
Do not alter the settings of the carburetor, if the
engine performance is good.
If necessary, adjustments should be recorded
existing (No. of turns) screw
mixture.
To verify the configuration of the screw
demezcladelcarburador, sigael
CO adjustment procedure "
Ensure the correct installation of blanking plug
6. Fit:
Engine idle stop screw
accelerator "1"
Engine idle R.P.M.
1300 to 1500 RPM
SET CABLE FREE PLAY
THROTTLE
NOTE:
Before adjusting the throttle cable free play
throttle, adjust the engine idle
1. Check
Slack "to" throttle cable
Out of specification →Adjustment
Throttle cable slack
3.0-5.0 mm
2. Adjustment
Throttle cable slack
Side of the carburetor
a. Loosen the locknut "1" cable
accelerator
b. Turn the adjusting nut "2" in direction "a"
or "b" until the free play is obtained
specified in the accelerator cable
Direction "a"
The free game accelerator cable
increases
Direction "b"
The free game accelerator cable
decreases
c. Tighten the lock nut.
1
to
b
NOTE:
If you can not get the specified free play
throttle cable on the side of the carburetor,
using the adjusting nut on the side of the handlebar.
Keep the handlebars straight.
Side of the handlebar
a. Slide back the rubber cover "1"
b. Loosen the lock nut "2"
c. Turn the adjusting nut "3" direction "a" or
"B" until the free play is obtained
specified in the accelerator cable
Direction "a"
The free game accelerator cable
increases
Direction "b"
The free game accelerator cable
decreases
1
to
2
d. Tighten the locknut
e. Slide the rubber to its original position
WARNING
After adjusting the throttle cable free play
pedal, start engine and turn the handlebars
right or left to ensure that
this does not produce changes in the idle
motor.
3-6
ENGINE
5
b 3