Inspection Of The Wheels; Inspection And Lubrication Cables; Lubrication Lever Clutch; Engine - Yamaha FZ-16 Service Manual

WARNING
Do not use tubeless tire on a wheel
tires designed only for camera
failures and avoid personal injury due to
sudden deflation.
After extensive testing, the tires
listed below have been
approved by Yamaha for this model.
Front and rear wheels should be
always the same manufacturer and same
design. There is no guarantee
management features that can be given
if combined tires that have not been
YAMAHA approved for this vehicle.
Front rim
Size
100/80-17M/C 52P
Manufacturer / Model:
MFR / ZAPPER-X
Rear tire
Size
140/60-R17M/C 63P
Manufacturer / Model:
MFR / ZAPPER revz
WARNING
The new tires have a relatively
grip under the tread to
that wear slightly. Therefore
should flow about 100 km at a
normal speed before driving at high
speed.
NOTE:
For rims with rotation mark "1":
Assemble the tire with the mark pointing in
the direction of rotation of the wheel.
Align the mark "2" with the mount point
the valve.

INSPECTION OF THE WHEELS

The following procedure applies to both
wheels.
1.
Check:
Wheels.
Damage / deformacionesReemplazar.
WARNING
Never attempt any repairs
wheels.
NOTE:
After a tire or a wheel has been
changed, the wheel must be balanced.
INSPECTION AND LUBRICATION
CABLES
The following procedure applies to
internal and external cables
WARNING
The exterior of the damaged cable can cause
corrosion in the cable and interfere with their
movement. Replace cables and outdoor
inside damaged as soon as possible.
1.
Check:
Cable outer.
Damnificadoreemplace.
2.
Check:
Operation of the cable.
IrregularLubrique movement.
Recommended lubricant
Engine oil or lubricant
appropriate cable.
NOTE:
Hold the cable end in a vertical position
and pour a few drops of lubricant on the cover of
cable or use a suitable lubricating device
LUBRICATION LEVER
CLUTCH
Lubricate the pivot points and moving parts
metal-metal of the lever.
Recommended lubricant
Based grease lithium soap
3-20
CHASSIS