Ethernet Interface Card Running Status Check - Zte ZXA10 C300 Maintenance Manual

Indicator
ACTi (i = 1 – 4)

2.2.6 Ethernet Interface Card Running Status Check

The ZXA10 C300 uses the following Ethernet interface cards:
l
8-port
l
2-port 10GE and 8-port GE Ethernet interface card: HDTT
Table 2-13
Table 2-13 Indicator Description of Ethernet Interface Cards
Indicator
RUN
SJ-20130520164529-008|2013-06-30 (R1.0)
Status
Green LED flashes slowly
every two seconds.
Red LED is ON.
Red LED flashes slowly
every two seconds.
Yellow LED flashes slowly
every two seconds.
Green LED is OFF.
Green LED is ON.
Green LED flashes.
GE Ethernet interface card: GDFO
describes the indicators of the Ethernet interface Cards.
Status
OFF
Green LED is ON.
Green LED flashes quickly.
Green LED flashes slowly
every two seconds.
Red LED is ON.
Red LED flashes slowly
every two seconds.
Yellow LED flashes slowly
every two seconds.
Chapter 2 Routine Maintenance
Description
The card runs properly.
Card hardware failure
The card is installed in the wrong slot.
The software version of the card does not match
that of the switching and control card. Auto-update
is not configured on the card.
The interface is not connected.
The interface is connected (LINK).
The interface is sending and receiving the data
(ACTIVE).
Description
The card powers OFF or
The card self-checking completes but fails to
receive data from the switching and control card
or NM.
The card is downloading data from the main control
card or NM.
The card is working properly.
Card hardware failure
The card should not be inserted in this slot.
The software version of the card does not match
that of the switching and control card. Auto-update
is not configured on the card.
2-11
ZTE Proprietary and Confidential
CPU is not started.