Pon Interface Card Running Status Check - Zte ZXA10 C300 Maintenance Manual

ZXA10 C300 Maintenance Manual
Indicator
M/S
HDD
ACTi (i = 1 - 4）

2.2.4 PON Interface Card Running Status Check

The ZXA10 C300 uses the following PON interface cards:
l
GPON interface card: GTGH and GTGO
l
XG-PON1 interafce card: GTXO and GTXQ
GPON Interface Card Running Status
Table 2-7
Table 2-7 Indicator Description of GPON Interface Cards
Indicator
RUN
SJ-20130520164529-008|2013-06-30 (R1.0)
Status
Red LED flashes slowly
every two seconds.
Yellow LED flashes slowly
every two seconds.
Green LED is ON.
OFF
Red
Green LED is ON.
Green LED flashes.
OFF
describes the indicators of the GPON interface cards.
Status
OFF
Green LED is ON.
Green LED flashes
irregularly.
Green LED flashes slowly
every two seconds.
Red LED is ON.
Red LED flashes slowly
every two seconds.
Description
The card is installed in the wrong slot.
The software version of the card does not match
that of the switching and control card. Auto-update
is not configured on the card.
The card is active.
The card is standby.
The control and switching card is operating flash.
Card plug-in/plug-out is not allowed.
The link is established.
The optical interface is sending and receiving data.
The link is not established.
Description
l
The card is not powered ON.
l The card does not match.
l CPU is not started.
The card self-checking completes but fails to
receive data from the switching and control card
or NM.
The card is downloading data from the network
management server.
The card runs properly.
Card hardware failure
The card is installed in the wrong slot.
2-6
ZTE Proprietary and Confidential