Table of Contents
Advertisement
Rear brake pedal
To adjust the position of the rear brake pedal, loosen
lock nut (4), turn pedal stroke adjuster screw (5) until
obtaining the required position. Tighten the counter
nut (4).
Operate the pedal by hand to check that there is
about 0.06-0.08 in (1.5-2 mm) of free play before the
brake bites.
If not, adjust the length of the master cylinder
pushrod as follows.
Loosen lock nut (6) on master cylinder rod.
Tighten rod on fork (7) to increase clearance or loosen
it to decrease it.
Tighten lock nut (6) and check again clearance.
5
4
Fig 94
6
7
Fig 95
173
Advertisement
Table of Contents
