KEB COMBIVERT F5 Instruction Manual page 2

This instruction manual describes the power circuits of the series KEB COMBIVERT F5 housing size W. It is only valid
together with the instruction manuals part 1 and part 3. Both instruction manuals must be made available to the user. Be-
fore working with the unit the user must become familiar with it. This includes especially the knowledge and observance
of the safety and warning directions of Part 1. Non-observance of the safety instructions leads to the loss of any liability
claims. The pictographs used in this instruction manual have following meaning:
Danger
Warning
Caution
Attention
observe at
all costs
Information
Aid
Tip
The information contained in the technical documentation, as well as any user-specific advice in spoken and written and
through tests, are made to best of our knowledge and information about the application. However, they are considered for
information only without responsibility. This also applies to any violation of industrial property rights of a third-party.
Inspection of our units in view of their suitability for the intended use must be done generally by the user. Inspections are
particulary necessary, if changes are executed, which serve for the further development or adaption of our products to
the applications (hardware, software or download lists). Inspections must be repeated completely, even if only parts of
hardware, software or download lists are modified. Original spare parts and authorized accessories by the manufacturer
serve as security. The use of other parts excludes liability for the damages which can result from it.
Application and use of our units in the target products is outside of our control and therefore exclusively in the area of
responsibility of the user.
Repairs may only be carried out by the manufacturer or an authorised repair agency. Unauthorised opening and tampe-
ring may lead to bodily injury and property damage and may entail the loss of warranty rights.
Is used, if life or health of the user are endangered or substantial damage to pro-
perty can occur.
Is used, if a measure is necessary for safe and trouble-free operation.
Is used, if a measure simplifies the handling or operation of the unit.