Smdr; Installing Smdr; Programming Smdr - NEC DS2000 Hardware Manual

Hide thumbs Also See for DS2000:

Table of Contents

SMDR

Station Message Detail Recording (SMDR) provides a record of the system's outside calls. Once set up in

programming, SMDR automatically outputs from the RS-232 (serial) port on the CPU to a customer-pro-

vided printer, terminal or SMDR data collection device. When connecting SMDR, you can use one of the

ready-made cables or make one of your own (see Figure 5-6 Making Your Own Data Cables on page 5-9).

To connect an SMDR device (Figure 5-4):

Plug the DIN end of the 8-Pin DIN to Mod-8 Cable (P/N 80893) into the CPU serial port.

Plug one end of the DB9 to Mod-8 Adaptor (P/N 85980) into the cable.

Plug the other end of the adaptor into the DB9M COM connector on the back of your PC.

0301: CPU Baud Rate

Assign the baud rate for the RS-232-C port on the CPU. The options are 0 (1200), 1 (2400), 2 (4800),

3 (9600), 4 (19200), and 5 (38400).

0301: SMDR Port

Enter 1 to enable SMDR output from the CPU RS-232-C port.

0301: Print SMDR Header

Enter Y to have the beginning of the SMDR report include the column header data. Enter N to have the

SMDR report only include the call data (without the header).

1001: Print SMDR

Enter Y to have the SMDR report include calls on the trunk. Enter N to have the SMDR report exclude

calls on the trunk.

4 Slot Cabinet

Shown

5-6 N Section 5: Maintenance Options and SMDR

You can also connect a PC to the CPU serial port to collect call history data.

The communications parameters of the CPU serial port are 19200 8 N 1 (19200 baud, eight

data bits, no parity and 1 stop bit).

If you have a PC connected to collect history data, press Shift 1 to turn history on and off.

You can also press Ctrl + Break on a PC connected to the CPU serial port to toggle through the

available CPU baud rates.

Figure 5-4: Connecting SMDR

DS2000 Hardware Manual

Table of Contents