Music Source; Installing A Music Source; Programming Background Music; Programming Music On Hold - NEC DS2000 Hardware Manual

Music Source

Installing a Music Source

Your system provides connection for a customer provided music source. Use this music source for Back-
ground Music and Music on Hold. Be sure the connected music source is compatible with the following
music input specifications:
The following products should help if you make your own cables. The connector is generally referred to as a
RJ45 connector wired in an RJ61X configuration. Check with your local supplier for comparable products.
G
Suttle SE-266-8K 8 Position Modular Plug (requires an SE-166 or SE-166-6 modular crimping tool).
G
Hubbell BRFT4P Snap-On 8 Position Modular Plug (does not require a special crimping tool).
To connect a music source (Figure 4-3):
1. Find an available connector in a station cable and make sure it is correctly punched down at the
66M1-50 block.
2. For the connector chosen, locate pins 2T and 2R and connect the music source.
3. Plug the modular jack into the CPU modular connector.
Latch
faces up

Programming Background Music

G
In 0201 - Background Music, enter Y to enable Background Music system-wide.
G
In 1802 - BGM, enter Y to enable Background Music at the extension.
To turn Background Music on and off:
1. Do not lift the handset or press SPK.
2. Press HOLD.

Programming Music on Hold

G
In 0201 - Music on Hold, enter Y to enable Music on Hold system-wide.
G
In 0201 - MOH on Transfer, enter Y to enable Music on Hold for transferred calls.
G
In 1003 - MOH Source, enter 1 (for external) + VOL
DS2000 Hardware Manual
Music Input Specifications
Input Impedance:
Output Level:
Follow standard color code order. Be sure the block is properly cross-connected.
RJ61X Port
To CPU
Pin Designation
Mod Jack
1 4T
2 3T
3 2T
4 1R
5 1T
6 2R
7 3R
8 4R
80000 - 18A
Note
reversal
Figure 4-3: Installing a Music Source
You can optionally enter 2 for a low pitched internal tone; 3 for a high pitched internal tone.
Music Source
10K Ohms
+18 dBr (+2 dBr) @ 1.0 KHz
To 66 Block
WHT-BLU (1T)
Page Out
BLU-WHT (1R)
WHT-ORN (2T)
Music In
ORN-WHT (2R)
WHT-GRN (3T)
Relay Contacts
GRN-WHT (3R)
WHT-BRN (4T)
No Connection
BRN-WHT (4R)
L
.
Section 4: Optional Equipment N 4-3
4