UAZ PATRIOT Operation Manual page 65

Fig. 3.13. Deflector:
1 — flap control lever; 2 — air currents
control lever
WARNING! Low air cooling of the windscreen is allowed when
the interior or foot air cooling mode is switched on.
When the interior heater is switched to any air cooling mode, the
presence of small air currents is allowed in directions different from
the selected mode, pictured on handle pictograph 2 (Fig. 3.13.).
Handle 3 (Fig. 3.13) controls the fan speed of the climate
control unit. Current position of the switch is shown by marker
5 on the moving part of the handle.
The switch has nine fixed positions: "Fan is turned off "
(leftmost position), maximum fan rotation speed (rightmost
position) and seven intermediate fixed positions between them.
For accelerating of stationary motor vehicle interior heating,
recirculation mode can be turned on
recirculation mode should be turned off to avoid window fogging.
On motor vehicles with additional interior heater, heating
rate of the rear triple passenger seat can be increased. In order
to do this, turn on the electric motor fan, additional heater
valve with electric drive 13 (Fig. 3.14) using the switch 5 (Fig.
3.7) positioned at the rear panel of the floor container.
Direction of air currents is adjusted by two deflectors.
Heating and ventilation system is equipped with an air-intake
filter. The filter should be changed after 15000 km mileage or
once per year, depending on what comes first.
Access to the filtering element is provided below the dashboard,
at the feet of the front passenger.
Changing of filtering element 5 (Fig. 3.15) should be performed
as follows:
- force latches 4 away from cover and remove cover 3;
- replace filtering element 5;
- lock filter cover 3.
. When in motion,
65