UAZ PATRIOT Operation Manual page 44

Driving mode change 2H=> 4H:
To switch on all-wheel drive "4H" mode:
- release accelerator pedal;
- press and hold the clutch pedal;
- set the handle from the "2H" position to the "4H" position.
If switching is successful, the symbol
cluster;
- release the clutch pedal.
If:
- efforts are made to switch all-wheel drive mode ON at the
moment of significant back wheel slip against the front wheel;
- a motor vehicle is driven with a pressure difference in the front
and back wheels exceeding the pressure difference specified in the
Manual;
- immediately before switching on turning with minimum possible
radius has been performed, or an effort to switch on is made
immediately when turning;
- in other exceptional cases, when front wheel and back wheel
drives will have different rpms at the moment of engagement
all-wheel drive; system switching over to the emergency mode is
possible, of which the simultaneous switching on of signal devices
is an indicator,
the back wheel drive remains active.
In this case, to switch the "4H" mode, it is necessary to set the
switch to the "2H" position and the "4H" mode should be switched
on again.
Driving mode change 4H=> 2H
To switch all-wheel drive mode OFF (engagement of back
axle drive "2H") it is necessary to:
- release accelerator pedal;
- press and hold the clutch pedal;
- set the handle from the "4H" position to the "2H" position.
If switching over is successful, the symbol
the cluster;
- release the clutch pedal.
Driving mode change 4H=> 4l
To switch on the mode of all-wheel drive with underdrive 4L
(beforehand the all-wheel drive "4H" mode must be switched
on), it is necessary to:
, and in the cluster. With that only
44
is switched in the
is switched off in