UAZ PATRIOT Operation Manual page 49

For this purpose it is necessary to switch the system over to
the "key upgrading" state and re-register keys:
- start up the ignition using one of the registered keys, turning
it into position I (Fig. 3.10) of the ignition starter switch;
- make sure that ignition is started up, key code is recognized
(the immobilizer turning-on signal device
- 10 seconds after starting up, shut ignition, turning the key
into the 0 position (Fig. 3.10);
- For 10 s start up the ignition using another registered key,
make sure that the ignition is started up, the key is recognized;
-10 s after starting up, shut ignition. The immobilizer turning-
on signal device
- For 20 s (signal device blinking time) press the accelerator
pedal. When the system recognizes full pressing of the accelerator
pedal, the The immobilizer turning-on signal device
- keep the accelerator pedal pressed for 60 s. After that the
immobilizer turning-on signal device starts blinking;
- For 20 s (signal device blinking time) start up the ignition
using the key to be registered (not the first and not the second
registered key). The immobilizer turning-on signal device is
continuously lit. Release the accelerator pedal. Key registration is
completed if in 2 s the signal device goes out. If the signal device
starts blinking, the key registration is considered incomplete and
the registration process is interrupted;
- 10 s after starting up the ignition, shut ignition and remove
the key from the ignition starter switch.The immobilizer turning-
on signal device will blink for 20 s. To register additional keys,
proceed with the previous operation;
- to finish the key registration, start ignition using the second
(from the start of the procedure) registered key. The immobilizer
turning-on signal device continues blinking for 2 s and then
switches OFF;
- 10 s after starting up the ignition, shut ignition and remove
the key from the ignition starter switch. The immobilizer turning-
on signal device starts blinking;
- For 20 s (signal device blinking time), start up the ignition
using the first (from the start of the procedure) registered key.
The signal device switches OFF. After that, the system deletes
all key codes registered during the previous teaching session
and registers all keys used in the current registration procedure
starts blinking, the system is ON;
49
is OFF);
is OFF;