UAZ PATRIOT Operation Manual page 45

- stop the motor vehicle;
- press and hold the clutch pedal;
- set the switch handle from the "4H" position through the
"4L" position to the unstable position "•" and hold it until the
signal device
- when the signal device
release the switch handle (the switch handle self-resets to the
"4L" position);
- start driving, smoothly releasing the clutch pedal.
Driving mode change 4l=> 4H
To switch on the mode of all-wheel drive with underdrive it
is necessary to:
- stop the motor vehicle;
- press and hold the clutch pedal;
- set the switch handle from the "4L" position to the "4H"
position;
- when the signal device
driving, having smoothly released the clutch pedal.
2 — fuel level sender switch in the tanks. Senders are switched
over by short pressing the central key zone. The signal device
lights up according to the connected sender: "L" — left tank,
"R" — right tank.
3+ — front seat heater switches.
4 — redundancy switches.
5+ — auxiliary heater speed control switch.
Low speed of the auxiliary heater electric motor is switched
on by short pressing the switch, at which point the left signal
device above the switch lights up. When the switch is short
pressed again, the high speed auxiliary electric heater motor
is switched on, additionally the right signal device lights up.
By short pressing the switch or when the key is removed, the
auxiliary heater and signal devices are switched off.
6+ — back seat heater switches. By short pressing the switch,
the heating of the respective seat switches on and the signal
device lights up. Seat heating and the signal device are switched
off when the switch is pressed again or when the key is removed.
in the cluster switches on;
switches on in the cluster, start
45
switches on in the cluster,