UAZ PATRIOT Operation Manual page 48

- the system is in the "key teaching" state — the signal device
switches on 4 times for a period of 3 s (1.5 s — OFF/1.5
s — ON).
Keys registration. Only ignition keys that are in "initial" and
"registered" states (previously registered in the system) are subject
to the registration. Keys registered in other systems cannot be
re-registered in this system. The registration is only possible using
any two keys that are registered in the previous key registration
session.
Key registration with the system in the "taught" state is used
to ensure that the motor vehicle owner have additional available
ignition keys (without deleting codes registered in the previous
ignition key registration session).
In order to register a key it is necessary to carry out the
following operations:
- start up the ignition using one of the registered keys, turning
it into position I (Fig. 3.10) of the ignition starter switch;
- make sure that ignition is started up, key code is recognized
(the immobilizer turning-on signal device
- 10 seconds after starting up, shut ignition, turning the key
into the 0 position (Fig. 3.10);
- For 10 s start up the ignition using another registered key,
make sure that the ignition is started up, the key is recognized;
- 10 s after starting up, shut ignition. The immobilizer turning-
on signal device
- For 20 s (signal device blinking time) start up the ignition
using the key to be registered. Registration is completed if in
5 seconds the signal device goes out. If the signal device is lit
continuously (without blinking), the key registration is considered
incompleted.
If a larger number of keys should be taught, repeat the key
registration procedure.
WARNING! Switching on the starter or violation of the specified
time intervals or switching OFF the power supply system prevent
logging on the key registration procedure, and if the system is already
in the procedure, interrupt all further key registration operations.
Key re-registration is used if at least one key is lost, and
to register additional keys (by deleting codes of the previously
registered keys).
starts blinking, the system is ON;
48
is OFF);