UAZ PATRIOT Operation Manual page 56

When armed mode is switched ON the system monitors the
states of the following security zones:
- side doors;
- cowl;
- T/gate;
- ignition starter switch;
- driver side door lock;
- accumulator battery voltage.
If any of the following actions take place in the armed mode:
- opening of any side door;
- cowl opening;
- T/gate opening;
- ignition start up;
- driver side door unlocking;
- accumulator battery connection after its disconnection,
the alarm system switches ON as T/signals light alarm and an
audible standard motor vehicle horn alarm for about 30 s.
Single pressing any button on the RCP when the system is
in alarm mode leads to interruption of alarm signal sending but
the system remains in armed mode. Armed mode is switched
OFF after button 2 on the RCP is pressed.
A lithium battery, CR2032 type, is installed in the RCP, its
initial voltage is 3V. If the RCP's supply voltage is within normal
range, indicator 1 flickers with every pressing of any button on
the control panel. If the indicator lights up with two short flickers
or does not light up at all when pressing any button, the battery
should be replaced.
For this purpose, unscrew screw 1 (Fig. 3.15) from the housing
side, opposite to the control buttons; using a flat screwdriver,
separate the housing halves; pull the board out of the housing;
replace battery 2 observing connection polarity; insert the board
into the housing; clip the housing's halves and tighten the screw.
When the control panel's buttons are pressed out of the radio
channel range, the floating code counter in the control panel falls
out of synchronization with respect to the counter in the system
control unit. If the number of control panel button pressings
System operation in armed mode
RCP battery replacement
RCP code re-synchronization
56