UAZ PATRIOT Operation Manual page 54

Remotely switching alarm system ("Panic") ON
To switch alarm system ON remotely, it is necessary to
press button 4 of the RCP twice or hold it pressed for at least
2 seconds. The alarm system switches ON for 5 s. To switch it
OFF, press any button of the RCP.
Switch prompt alarm ON is only possible with started up
ignition. Switching ON is performed by pressing button 4 of
the RCP and holding it for at least 2 s. To switch prompt alarm
OFF, press any button of the RCP.
Locking and unlocking central door locks from the interior
Locking all door locks (including the T/gate) from the motor
vehicle interior is possible using 2 methods:
- sink the interlocking switch in the driver side door to lock,
and pull the interlocking switch in the driver side door to unlock;
- press switch 2 (Fig. 3.14) of the DSDM. Every press either
locks or unlocks the locks.
The central locking has door lock overheating protection.
If locking or unlocking is performed many times over a short
period of time, the system stops responding to switch pressing. If
it has happened, the switch should not be pressed for some time
(depends on overheating degree), after that, system availability
will be fully recovered. To ensure safety, the last command is
always the unlock command.
In the fast unlocking mode, when opening the driver side door
with the key, only the driver side door is unlocked, to unlock
passenger doors and the T/gate press button 2 of the RCP or
switch 2 of the DSDM
Position of all side door windows is controlled in the same
way.
Window position is controlled by the switches located on
the armrests of the respective motor vehicle doors. Side door
window positions are controlled by moving switches 3, 4, 5, 6
(Fig. 3.14) on the driver's door armrest.
Button 1 of the DSDM allows control of passenger door
window positions (all three passengers doors) from the switches
installed on the passenger door armrests to be disabled. If
Switching prompt alarm ON
Side door window position control
54