After The Fuel Runs Out - Takeuchi TB014 Operator's Manual

TROUBLESHOOTING
If the Battery Goes Dead
Disconnecting the jumper cables
Once the engine starts, disconnect the
jumper cables following the connection
procedure in reverse order.
Rescue vehicle battery
3
R
2
B
1. Disconnect the clip of jumper cable (B)
from the problem vehicle's engine block.
2. Disconnect the other clip of jumper cable
(B) from the rescue vehicle's "–" terminal.
3. Disconnect the clip of jumper cable (R)
from the rescue vehicle's "+" terminal.
4. Disconnect the other clip of jumper cable
(R) from the problem vehicle's "+" terminal.
Recharging
Have a Takeuchi sales or service outlet
recharge batteries that have gone dead.
Problem vehicle battery
4
From engine block
1
E4J006
TROUBLESHOOTING

After the Fuel Runs Out

Bleeding the Air from the Fuel
System
1. Add fuel.
2. Open the water separator and fuel filter
cocks.
PREHEAT
3. Turn the starter key to the ON position and
hold it there for about 20 seconds.
The automatic air bleeder bleeds the air
from the fuel system.
4. Start the engine and inspect for fuel
leakage.
Supplement: Air in the fuel system can
make it difficult to start the engine and cause
engine problems. Also bleed the air when
the fuel tank is emptied or air in the fuel
system.
141
OFF
ON
START
E4D002