Takeuchi TB014 Operator's Manual page 60

CONTROLS
Accessories
(15) DISP (Time/Frequency) button
This system is equipped with a clock which
can show the accurate time. Even if the radio
is off, the clock still shows the time.
(16) PS / AS switch
Pushing this button for 2 seconds down will
automatically operates to show the
memorized station from 1 to 6. The signal
scanning start by pushing this button
momentarily. When a station is received the
scanning automatically stops there for 5
seconds FLASHILY and then resumes
scanning. As soon as the desired station is
found, press the this button again.
If you will auto memory push this button over
5 sec so initiates a scan of the band. Station
frequencies are either stored in order of low
of frequency for FM, or in sequence for AM,
starting from preset channel 1. If all of the
preset channels have not been filled up after
one scan, the remaining preset channels are
left unchanged, and channel 1 is recalled.
Channel 8 flashes during A.
¡ ¡ ¡ ¡ ¡ Set the time
Hour
After pressing DISP button, press tuner
button or to correct the time. Press tuner
button to set the "hour" and tuner button
for setting the "minute". Set the time when
the time is shown.
Minute
C4C023
58
External Power Sockets (for EU)
WARNING
Only use applicable electric products with
these sockets.
1
for Beacon
1
Use these sockets as an external power
supply. When using these sockets, be
careful not to exceed 12V/10A.
To use, raise the cap (1).
Applicable plug: BOSCH 0352321007
C4C0281
N0C008