When Required - Takeuchi TB014 Operator's Manual

MAINTENANCE

When Required

Replacing the Bucket Teeth
WARNING
¡ ¡ ¡ ¡ ¡ Before performing maintenance or
repairs under the machine, set all
working equipment against the ground
or in the lowermost position.
¡ ¡ ¡ ¡ ¡ To prevent unexpected movement,
securely block the hoe attachment
when repairing or replacing the cutting
edges or bucket teeth.
¡ ¡ ¡ ¡ ¡ Wear required appropriate equipment
such as safety glasses when using
hammers, as metal fragments or other
objects can fly and cause serious
personal injury.
¡ ¡ ¡ ¡ ¡ Do not allow unauthorized personnel
in the work area.
IMPORTANT: The
damaged if the teeth are not replaced at
the proper interval. Replace the teeth if
they wear down to 140 mm (5.5 in.).
Removal
C4G029
bucket will be
E4G042
1. Set the bucket with its bottom flat on a
block and the teeth sticking off the block.
2. Check that the bucket does not move, then
set the safety lock lever to the locked
position and stop the engine.
2
3. Remove the bolt (1).
4. Remove the tooth (2) and shim (3).
Installation
1. Insert the tooth (2) into the bucket (4).
2. If the tooth is loose, insert the shim (3)
and adjust it.
3. Insert the bolt (1) from the outer (lower)
side of the bucket and tighten it with a nut.
Tightening torque: 102 N·m (75.2 ft-lb.)
4. Use a punch to caulk or spot-weld the
bolt's thread on the nut side at three
places.
129
1 4
3
C4G028
C4G030