Attaching The Port Side Of The Chassis To The Cabinet Rails - IBM SAN768B-2 User Manual

Figure 9. Attaching the port side of the chassis to the cabinet rails
21. Reinstall the cable management comb, if it was removed (see "Removing and
22. If ICL cables will not be used, ensure that the ICL sockets in the core switch
23. Reinstall the chassis door. Align the door with the chassis and push it into
26
SAN768B-2 Installation, Service, and User Guide
clip nuts ( D ) or retainer nuts ( F ) installed on the rails earlier. Tighten the
screws to a torque of 37 cm-kg (32 in-lb). See Figure 9 for the approximate
location of the screws.
Note: Do not use the top or bottom holes of the SAN768B-2 mounting
brackets because the screw heads will interfere with the chassis door.
installing a cable management comb" on page 82).
blades have EMI plugs inserted.
place, as shown in Figure 10 on page 27 and Figure 11 on page 28.