IBM SAN768B-2 User Manual page 149

File Name [config.txt]: config-switch0.txt
Password:
Upload complete
switch:admin>
Alternatively, you can save the configuration file to the USB device.
3. Record the SAN768B-2 values on a workstation, following steps 4 through 9
below.
4. Record the WWN value: Enter wwn, then copy the command output into a file
named configmiscinfo.txt.
switch:admin> wwn
10:00:00:60:69:00:00:0a
5. Record the IP address information. Enter ipAddrShow -sw, then copy the
command output into the config-miscinfo.txt file.
switch:admin> ipaddrshow -sw
Ethernet IP Address: 10.32.50.12
Ethernet Subnetmask: 255.55.0.0
Fibre Channel IP Address: 1.2.3.4
Fibre Channel Subnetmask: 255.255.255.0
CP0
Ethernet IP Address: 10.32.50.10
Ethernet Subnetmask: 255.55.0.0
HostName : cp0
Gateway Address: 10.32.40.1
CP1
Ethernet IP Address: 10.32.50.11
Ethernet Subnetmask: 255.55.0.0
HostName : cp1
Gateway Address: 10.32.40.1
Backplane IP address of CP0 : 10.0.0.6
Backplane IP address of CP1 : 10.0.0.7
switch:admin>switch:admin>
6. Display and record the manufacturer serial numbers. Enter chassisShow, then
copy the command output into the config-miscinfo.txt file.
"Factory Serial Num" and "Serial Num" are listed under "Chassis/WWN Unit
1." If the current WWN cards are the original cards, the factory serial number
listed is the same as the chassis serial number. If a "Serial Num" value
displays, contact IBM to determine whether this serial number should be
modified after the new WWN card is installed.
switch:admin> chassisshow
Chassis Backplane Revision: 1F
SW BLADE Slot: 1
Header Version: 2
Power Consume Factor: -50
Factory Part Num: 60-0001532-03
Factory Serial Num: KP000000195
Manufacture: Day: 1 Month: 1 Year: 2011
Update: Day: 14 Month: 3 Year: 2011
Time Alive: 187 days
Time Awake: 3 days
<output truncated>
CHASSIS/WWN Unit: 1 (in same assembly as WWN Unit: 2)
Header Version: 2
Power Consume Factor: -3
Factory Part Num: 60-0001501-07
Factory Serial Num: FT02X805BE2
Manufacture: Day: 26 Month: 3 Year: 2011
Update: Day: 14 Month: 3 Year: 2011
Chapter 5. Removing and installing components
121