IBM SAN768B-2 User Manual page 111

2. Remove the cables from the cable management comb and rearrange the cables
around the comb.
3. Unscrew and save the four screws holding the comb to the chassis (see
Figure 30). Support the comb to prevent it from falling.
4. Remove the cable management comb.
Figure 30. Cable management comb
Installing a cable management comb
Complete the following steps to install a cable management comb.
1. Align the comb with the four screw holes on the chassis.
2. Position, insert, and tighten the four screws to secure the cable management
comb to the chassis.
3. Arrange the cables along the cable management comb.
4. Replace the chassis door.
Chapter 5. Removing and installing components
83