Chassis Slots - IBM SAN768B-2 User Manual

|
| | |
| | |
|
|
|
|
|
|
|
|
| | |
| |
|
|
|
|
| |
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|

Chassis slots

30
SAN768B-2 Installation, Service, and User Guide
Table 6. Blade port numbering (continued)
Blade
FS8-18 blade
FX8-24 blade
Slots are numbered 1–12, from left to right when facing the port side of the
SAN768B-2. Control processor blades (CP8) can be installed only in slots 6 and 7.
Core switch blades (CR16-8) can be installed only in slots 5 and 8. Port or
application blades can be installed in slots 1–4 and 9–12. Unused slots must be
filled with blade filler panels to maintain adequate cooling.
See Appendix E, "Blade port numbering," on page 175 for port numbering details
of the SAN768B-2 port blades. Also, see the IBM Redbook, Implementing an
IBM/Brocade SAN with 8 Gbps Directors and Switches, SG24-6116, for more
comprehensive information on port numbering and area port numbering, and
other technical information. This publication is available through
http://www.redbooks.ibm.com/. Search by title or publication number.
Note: This publication was written for earlier products, but many of the
procedures still apply.
Port numbering
v The 16 physical Fibre
Channel ports on this
blade are numbered 0
through 15 from bottom to
top.
v The two 10/100/1000
BaseT ports are numbered
from the bottom as GE0
and GE1.
Ports are numbered in
groups.
v The FC ports are
numbered from 0 through
11 in two vertical columns
of six ports starting from
the bottom left and bottom
right in the lower group of
12 ports. They are labeled
FC on the front panel
diagram.
v The two 10-GbE ports are
0 and 1 and are in the left
column just above the FC
ports. They are labeled
10GE on the front panel
diagram.
v The ten 1-GbE ports are
numbered 0 through 9 and
are in both columns above
the FC and 10GE ports.
They are labeled GE on
the front panel diagram.
See Figure 61 on page 185 for
an illustration of the blade.
Trunking port groups
0-7 and 8-15
Up to three FC trunking
groups are permitted. The
three groups are defined as
follows:
v Trunk group 0: FC ports 0,
1
v Trunk group 1: FC ports 6,
7
v Trunk group 2: FC ports 2,
3, 4, 5, 8, 9, 10, 11