Attaching The Port Side Of The Chassis To The Cabinet Rails - IBM SAN768B-2 Installation, Service And User Manual

15. Remove the retention straps.
16. Slide the SAN768B-2 into the cabinet until it rests securely on the shelf
17. Remove the wheel chocks, release the wheel brake, and move the lift tool
18. Uninstall the bridge tool and return it to its original box.
19. Reinstall the power supplies and blower assemblies if any were removed.
20. Fasten the port side of the chassis to the cabinet rails. Use three 10–32 x
Figure 9. Attaching the port side of the chassis to the cabinet rails
21. Reinstall the cable management comb, if it was removed (see "Removing and
22. If ICL cables will not be used, ensure that the ICL sockets in the core switch
23. Reinstall the chassis door. Align the door with the chassis and push it into
24
SAN768B-2 Installation, Service, and User Guide
brackets.
away from the cabinet.
5/8-in. Phillips panhead screws with washers C on each side to attach to the
clip nuts ( D ) or retainer nuts ( F ) installed on the rails earlier. Tighten the
screws to a torque of 37 cm-kg (32 in-lb). See Figure 9 for the approximate
location of the screws.
Note: Do not use the top or bottom holes of the SAN768B-2 mounting
brackets because the screw heads will interfere with the chassis door.
installing a cable management comb" on page 68).
blades have EMI plugs inserted.
place, as shown in Figure 10 on page 25 and Figure 11 on page 26.