Read and understand the instruction manual
before installing or operating.
This product is solely intended for plasma cutting. Any other use may result in
personal injury and / or equipment damage.
5
INTRODUCTION
The EPP power source is designed for marking and high speed plasma mechanized
cutting applications. It can be used with other ESAB products such as the PT-15,
PT-19XLS, PT-600 and PT-36 torches along with the Smart Flow II, a computerized
gas regulation and switching system.
5.1
Features
10 to 36 amperes for marking
S
30 to 360 amperes cutting current range
S
Forced air cooled
S
Solid state DC power
S
Input voltage protection
S
Local or remote front panel control
S
Thermal switch protection for main transformer and power semiconductor
S
components
Top lifting eyes or base forklift clearance for transport
S
Parallel supplemental power source capabilities to extend current output range
S
bp12a1
- 16 -
© ESAB AB 2010