ESAB EPP-360 Instruction Manual page 29

US
A - Preset / Operate Switch
"Center" position = will show actual cut parameters
S
"Up" position = Pilot Arc Current Preset for either the Panel or Remote mode
S
"Down" position = Cut Current Preset for either the Panel or Remote mode
S
B - Over Temp
Indicator illuminates when power source has overheated.
C - Fault
Indicator illuminates when errors have occurred which require a main power reset of
the unit.
D - Current Dial (Potentiometer)
EPP-360 dial shown. EPP-360 has a range of 10 to 360 amps. Used only in panel
mode.
E - Panel Remote Switch
Controls the location of current control
Place in the PANEL position for control using the current potentiometer.
S
Place in REMOTE position for control from an external signal (CNC).
S
F - Meters
Displays voltage and amperage when cutting. The ammeter can be activated when
not cutting to view an estimation of the cutting/marking current or pilot arc current
before cutting begins. See "A" above. Also displays various error codes that may
occur.
G - E-Stop Connector (not shown)
The E-stop connector provides a normally closed contact of the E-stop switch. The
contact is connected to J4-A and J4-B. The contact opens after the E-stop button is
pushed. This provides a signal to the plasma control that the power source is in an
E-stop condition.
H - E-Stop Button
The E-stop button operates the E-stop switch. When the button is pushed in, an
E-stop condition exists which prevents the power source from providing output even
when a start signal is provided.
J - CB1 - 3 amp
Circuit breaker for 115VAC to CNC.
bp12a2
- 29 -
© ESAB AB 2010