Canon DR-5020 Instructions Manual page 68

Chapter 2 Scanning a Document
Control
sheet
Feeding
Option
Backside
setting
• When the [Backside scanning] checkbox is marked, the Feeder setting when the
[Start Scanning] dialog box is opened becomes [Simplex].
MEMO
• When scanning is performed with the [Backside scanning] checkbox marked and
Feeder setting set to [Duplex], the Backside scanning checkbox becomes is gray
when the [Detailed Settings] dialog box is opened.
• A gray [Backside scanning] checkbox can be restored to normal by clicking the
checkbox.
66
Selects how the scanner detects scanner Control Sheets
(Function Sheets) (P.48).
-None
Scanner Control Sheets are not detected.
-Scan, Continue scanning
The scanner Control Sheet is detected and scanned, and then
scanning continues.
-Skip, Continue scanning
The scanner Control Sheet is detected and skipped (not
scanned), and then scanning continues.
-Scan, Stop scanning
The scanner Control Sheet is detected and scanned, and then
scanning stops.
-Skip, Stop scanning
The scanner Control Sheet is detected and skipped (not
scanned), and then scanning stops.
For details on how to scan with Control Sheets, see "Function
Sheets" in the separate DR-5020/5080C Instructions.
Selects the feed method.
Remote: The document starts to be fed (scanned) when
you load the document and instruct scanning in
the application.
Semi Auto: The document is fed (scanned) when scanning is
instructed in the application and when you load the
document and press the Start key.
Auto: The document is fed (scanned) automatically when
you load the document.
Manual: The document is fed manually one page at a time
after scanning is instructed in the application. Use
this when scanning particularly thick or thin pages.
This item can be also set on the scanner's operation panel. For
details, refer to the separate DR-5020/5080C Instructions.
Set this item to scan the back side of documents.
[Backside scanning]
Scans the back side of the document (documents are loaded
face down on the scanner).
[Backside brightness]
Automatically or manually sets the brightness of the image.
When you manually set the brightness, you can set within the
range 1 to 255.