Paradyne 3800 User Manual page 49

COMSPHERE 3800 Series Modems
Call Setup Branch
In the following descriptions, the shaded key indicates
what key to press to perform the described operation.
To access the Call Setup branch from the Top-Level
menu, select Call_Setup:
Idle: 19.2
Call_Setup
F1 F2
Dial
Dial allows you to dial any telephone number stored in
directory locations 1–10. Any telephone number dialed
using the DCP must already exist in a directory location.
Refer to Change Directory for information on storing
telephone numbers in directory locations.
To access Dial from the Call Setup branch, make the
following selection:
Call Setup:
Dial Disconnect
F1 F2
5-2
>
F3
>
F3
September 1998
Select Dial to display the first directory telephone
number.
Dial Directory:
Nxt 01:5551234
F1 F2
To view other directory locations, select Nxt.
Dial Directory: 01
Dialing
F1 F2
Once the directory location you want appears on the
LCD, press the F2 or F3 key to dial the number.
If the connection is successful, the modem is online
and one of the Normal Operation status messages appears
on the LCD. If the connection is not successful, the LCD
displays one of the Call Failure status messages. (See
Table 4-4 in Chapter 4.)
AT Command Equivalent
The AT command equivalent for Dial is DS=n, where n
is directory location 1–10.
F3
F3
3810-A2-GB30-30