Paradyne 3800 User Manual page 146

AT
Command
Identification
In
I0 Displays product code; default is 144.
Displays 3-digit firmware revision number.
I1
Performs an EPROM check.
I2
I3 Displays the modem's serial number.
Displays the modem's model number.
I4
Displays the part number of the circuit card.
I5
I6 Displays the firmware release number.
Displays 3-digit firmware revision number (same as I1).
I9
I10=n Changes the value of the product code displayed by the I0 command; n
is a number from 0 to 4:
I10 = 0 sets product code to 144
I10 = 1 sets product code to 240
I10 = 2 sets product code to 480
I10 = 3 sets product code to 960
I10 = 4 sets product code to 120
Performs a checksum of the modem's firmware and displays the results
I11
in hexadecimal. (There is no DCP equivalent of this command.)
Displays the last sequence fault record.
I17
I19 Displays the entire firmware revision level.
Ln Speaker Volume
L0 Selects low volume.
L1 Selects low volume.
L2 Selects medium volume
L3 Selects high volume.
Mn Speaker On/Off
M0 Speaker always off.
M1 Speaker on until carrier signal is detected.
M2 Speaker always on.
O Return to Online or Data Mode
Returns modem to Data mode from Online Command mode.
P Pulse Dial
Sets the modem for pulse dial mode.
Qn Result Codes
Q0 Enables modem to send result codes to the DTE.
Q1 Disables modem from sending result codes to the DTE.
Q2 Enables in Originate mode only for modem to send result codes to the
DTE. Required for most UNIX applications.
Sr =n Change S-Register
Changes contents of S-register (where r is the S-register, and n is the new
value).
Sr ? Display S-Register
Displays value of S-register where r is the S-register number.
3810-A2-GB30-30
Table 14-1
(3 of 12)
3800 Series AT Commands
Description
September 1998
AT Command Set and S-Registers
Front Panel
Branch
Status\Identity
Control\Speaker
Configure\Edit\Misc
Control\Speaker
Configure\Edit\Misc
None
Configure\Edit\Line
Dialer
Configure\Edit\DTE
Dialer
None
None
14-5