Paradyne 3800 User Manual page 153

COMSPHERE 3800 Series Modems
AT
Command
\An Maximum Frame Size
\A0 64
\A1 128
\A2 192
\A3 256
\A4 32
\A5 16
\Cn Error Control Negotiate Buffer
\C0 Disable.
\C1 Enable.
\C2 Disables and switches modem to Buffer mode.
\Dn CTS Control
\D0 Forced On. Forces CTS to always ON.
\D1 Standard RS232.
\D2 Wink When Disconnect. CTS is turned Off for 1 to 2 seconds upon a
disconnect.
\D3 Follows DTR. The state of CTS follows the state of DTR.
\Gn Modem to Modem Flow Control
\G0 Disable.
\G1 Enable.
\Kn Break Buffer Control, Send Break Control, Break Forces Escape
Break
Buffer
Control
\K0 Discard Data
\K1 Discard Data
\K2 Keep Data
\K3 Keep Data
\K4 Keep Data
\K5 Keep Data
\K6 Discard Break
\Nn Error Control Mode
\N0 Buffer Mode.
\N1 Direct Mode.
\N2 MNP or Disconnect.
\N3 MNP or Buffer.
\N4 V.42/MNP or Disconnect.
\N5 V.42/MNP or Buffer.
\N6 LAPM or Disconnect.
\N7 LAPM or Buffer.
14-12
Table 14-1
(10 of 12)
3800 Series AT Commands
Description
Send Break
Break Forces
Control Escape
Break First Enable
Break First Disable
Break First Enable
Break First Disable
Data First Enable
Data First Disable
Not Applic. Disable
September 1998
Front Panel
Branch
Configure\Edit\
V42/MNP/ Buffer
Configure\Edit\
V42/MNP/ Buffer
Configure\Edit\DTE
Interface
Configure\Edit\
V42/MNP/ Buffer
Break Buffer Control:
Configure\Edit\
V42/MNP/ Buffer
Send Break Control:
Configure\Edit\
V42/MNP/ Buffer
Break Forces Escape:
Configure\Edit\DTE
Dialer
Configure\Edit\
V42/MNP/ Buffer
3810-A2-GB30-30