Paradyne 3800 User Manual page 147

COMSPHERE 3800 Series Modems
AT
Command
T Tone Dial
Sets the modem for tone dial mode.
Vn Result Code Format
V0 Displays result codes in Number (1) format digits.
V1 Displays result codes as text.
V2 Displays result codes in Number (2) format (digits).
Xn
Extended Result Code, Dial Tone Detect, and Busy Tone Detect
Configuration Options
Ext
Result Code
X0 Disable
X1 Enable
X2 Enable
X3 Enable
X4 Enable
X5 Add/EC
X6 Add/V42,MNP
X7 Use DTE Rate X7 Use DTE Rate
EXTENDED RESULT CODE
Enable. Displays all result codes listed in Table B-1 except for error control
suffix.
Disable. Only displays OK, CONNECT, RING, NO CARRIER, ERROR.
Add/EC. Displays result codes with /EC suffix. Add/V42,MNP. Displays result
codes with either V.42 or MNP suffix. Use DTE Rate. Displays DTE data rate
instead of line rate.
Add/V42,MNP. Displays result codes with either V.42 or MNP suffix.
Use DTE Rate. Displays DTE data rate instead of line rate.
DIAL TONE DETECT
Enable. Sets the modem for dial tone detect.
Disable. Sets the modem for blind dialing.
BUSY TONE DETECT
Enable. Modem monitors for busy tone.
Disable. Modem ignores busy tone.
Yn Long Space Disconnect
Y0 Disable. Ignores long space.
Y1 Enable. Disconnects if long space is detected. Enables transmission of a
long space.
14-6
Table 14-1
(4 of 12)
3800 Series AT Commands
Description
Dial Tone Busy Tone
Detect Detect
Disable Disable
Disable Disable
Enable Disable
Disable Enable
Enable Enable
Enable Enable
Enable Enable
Enable Enable Enable Enable
September 1998
Front Panel
Branch
Configure\Edit\Line
Dialer
Configure\Edit\DTE
Dialer
Extended Result Code:
Configure\Edit\DTE
Dialer
Dial Tone Detect:
Configure\Edit\Line
Dialer
Busy Tone Detect:
Configure\Edit\Line
Dialer
Configure\Edit\Line
Dialer
3810-A2-GB30-30